Dewey's DW901 Series Static Pressure Level Transmitter consists of three parts: measurement probe, junction box and fixed connector. The input type pressure sensor probe is sunk into the bottom of the container to measure the height of the liquid level, and the hydrostatic pressure is expressed by the formula P=Po+ρgh. Where Po is the pressure at the upper surface of the liquid, p is the density of the liquid to be measured, H is the height of the liquid column, and g is the acceleration of gravity (constant).

In order to eliminate the influence of the atmospheric pressure at the upper surface of the liquid, the DW901 transmitter adopts a ventilated cable design scheme to introduce the PO into the pressure-sensitive surface of the sensor to offset the effect of Po. It can be seen that the pressure P detected by the sensor has a linear relationship with the measured liquid level. The pressure signal is converted into a 4-20mA DC output signal by a single integrated V/I transmitter, and the height of the liquid level can be measured by measuring (recording) the output current value. When the output current reaches the set current value, a control or alarm signal can be sent through the optional controller. Sensor probes must be suspended or fixed at a certain height in order to achieve accurate measurements. When the medium flow or disturbance is large, the probe should be installed on the support frame or weighted hammer and hanging chain, or the probe can be placed in the anti-wave tube.

●Applicable media:Applicable to coexistence of 316 stainless steel and polyethylene. Hastelloy can be used to measure corrosive media. ●Measuring range: 0~0.5m to 0~600m

● Accuracy: 0.2%F. S

●Working temperature: -20°C~80°C (medium without crystallization)

●Storage temperature: -40°C~125°C

● Temperature coefficient: zero and ±0.015%F. S/°C

● Long-term stability: &plusmn;0.1%F. S/year ● Range migration: Model zero/range with silicon sensor is not available, output offset &lt;2%F. S, the migration ratio of a ceramic capacitive sensor is 5:1.</font></p>

● Power supply voltage: 12 to 36VDC standard 24VDC

● Output signal: two-wire system 4 ~ 20mA

●Load characteristics: standard 24VDC, load resistance &le;600&Omega;

● Overload: 3 times full scale ● Current limit protection: Under overload conditions, the power supply limit nominal 26mA

●Protection class: probe IP68, junction box IP67

● Explosion-proof grade: Intrinsically safe explosion-proof grade iaIICT5

● Ventilation cable: Polyurethane gas cable, with polymer screen. Flange mounting

Clear Ribbed Acrylic Sheet

Clear Ribbed Acrylic Sheet,Acrylic Translucent Sheet,Ribbed Acrylic Sheet,Clear Reeded Acrylic Sheet

Jiangmen Kunxin new Material Technology Co.,Ltd , https://www.jmkunxinplastics.com