1. The plasma power supply has inverter type and thyristor type, the former is light in weight.
2, consider the temporary load rate, the general domestic power supply is about 80%, a little better to reach 90% or even close to 100%. (The duty ratio, also called the duty continuation rate, is the rate at which this equipment can be fully loaded with working hours.)
3, according to the thickness of the sheet to be cut plasma current source size selection.
4. The length of the plasma cable shall take into account the distance between the torch and the plasma power supply within the full width range of the cutting process. However, the long cable will reduce its perforation and cutting ability.
5, plasma power supply, can be used for manual cutting, can also be used for supporting CNC cutting machine. In order to realize its cutting torch on the CNC cutting machine, it should be equipped with a straight shank cutting torch for the purchase.
6, ordinary plasma, slope of 15 degrees. Plasma power supply, according to the cutting section verticality, cutting accuracy, ordinary plasma, fine plasma, laser plasma. At the same time, their prices are also very different. According to the quality requirements of the cutting section, select the type and manufacturer of the plasma power supply. Plasma cutting, due to the large top of the melting hole, the following small, the incision section always has a certain degree of inclination, it is impossible to be as vertical as the flame cutting, this is a worldwide problem.
Chinese cutting machine trading network, allowing you to buy the rest assured! A variety of CNC cutting machine and CNC cutting equipment, a variety of cutting machine models, let the optional! Official website: /
CNC Aluminum Spare Part is those parts manufactured by CNC machine directly.It can greatly save the tooling cost if the required quantity of the parts is only in sample stage.CNC Aluminum Spare Part is precise in the dimension and the cutting burr is perfect.Also CNC Aluminum Spare Part surface can be better protected .It can fabricate small size Aluminum Sheet or spare parts. CNC Aluminum Spare Part is more precise of external dimension. The tolerance of the size is very small.
CNC milling Aluminum spare part, CNC Aluminum spare part,CNC Aluminum alloy spare part
Trumony Aluminum Limited , https://www.szaluminumpipe.com