Three roller gate installation process

Three-roll gate access control products are often used, but you may not understand the installation process in the end. You will understand the installation method and flow of the three-roll gate access control for you. First of all, how to properly install the three-roll gate access control should pay attention to the following issues:

The three-roll gate ban is completely communicative with the customer before starting the installation to understand the site's environmental conditions in order to determine the program:

First, develop a construction plan

Installation site is open or indoor use, in the open the use will have to choose to wear waterproof box tripod gate, in order to avoid the weather caused by the corrosion of the circuit board; waterproof box selection should also be more environmentally-friendly features, the South can use silicone rubber waterproof Box plus diffuse temperature system, the North can use iron waterproof box temperature control system.

According to the distance between the main control computer and the three-roll gate access control, the wiring mode is selected (whether it is the open line or the dark line and the communication mode of the controller (generally the distance between the computer and the three-roll gate access is within 800 meters, we suggest to choose 485 communication At distances above 800 meters we choose TCP network communications.

Please click here to enter a picture description

Second, the preparation before installation

Generally, two 6- to 8-minute plastic pipes are embedded in the site according to the actual size of the three-roll gate before installation. The clearance between the three-roll gate and the three-roll gate is 50-00mm, which is convenient for opening the top. Cover, adjust the machine, easy to maintain, etc., pre-embedded between equipment and equipment, must use a hose to take the power cord (strong power, another hose walking signal line (weak, can not take the power line and signal line at the same time a hose In this way, it is easy to produce security risks and the communication effect will also be affected.The pre-embedded pipe should be exposed to the ground with a height of 30-40mm. The bridge-type three-roll gate should be on both sides, and the vertical three-roll gate should be in the middle of the machine. .

Third, fixed adjustment

The fixed bottom is fixed with 4-M000 expansion screws and can not swing. The overall appearance of the whole machine is consistent. (Before fixing, the straight line is used to pull the straight line, and the vertical and horizontal directions are the same. The three roller gates and the three roller gates are connected in series and adjusted one by one. Until it can be used normally, the three-roll gate should be placed horizontally with the ground, so that the effect and the life of the three-roll gate will be in the most state.

Fourth, the importance of installing the ground

According to what I learned in the past, some customers did not have an effective connection line after installing the three-roll gate. The three-roll gate housing is mostly made of stainless steel. If the housing is not grounded, it will cause great safety hazards to the user's personal safety.

The three-roll gate access control is a product with a relatively large amount of use in the market. It has a strong ability to prevent tailgating, and is simple in operation and stability. The three-roll gate product is also the earliest channel product on the market. Follow-up swing gates, wing gates, and translating brakes are derived from the three-roll gate. If you still have something you don’t understand during the use process, you can contact us to understand the smart staff.