Anyone who has bought a car knows that it takes a certain period of adaptation before the new car lands to enable the various parts of the car to be well matched with each other. The same applies to bulk feed carriers. Therefore, by understanding the relationship between the adaptation period and the service life of a transport vehicle, it is possible to do a better job during the break-in period and allow the new vehicle to have a longer service life.
1. Above the carrying capacity, if the new car is driven at full capacity at the beginning, it will cause great damage to the various components in the car. In particular, if you use a very fast travel speed under full load, then the conversion span between the various gears in the car will be too large, which will quickly degrade the performance of the new car. Therefore, during the adaptation period of a new car, it should try not to allow the body's payload to exceed 70 to 80 percent of the rated capacity, and the speed of the vehicle should be kept as fast as possible at the middle speed. The new car has a longer life.
2. During the running-in period of a new car, it should be avoided as much as possible to urgently start braking. Too much braking will increase the load capacity of the engine, which will result in too much impact on the braking system and result in a poor performance of the entire system. Therefore, if you want a new car to drive longer, then within 300 kilometers of the initial period of the adaptation period, you should make sure that you do not always hang a gear or step on the clutch to let the new car brake.
3, the feed truck is not suitable for a long time on a very bumpy road, and when the vehicle's load is less than 90% of the rated capacity, it should try to choose a relatively smooth road ahead. This in turn allows the new car to avoid excessive vibration and reduce the load on the car's powertrain due to excessive vibration.
4, do not use a stall for a long time to drive, so for the novice, the brakes and shifts and other aspects are more smooth and smooth, but it will have a great deal of damage to the clutch. After the car has passed the first 300 kilometers of the run-in mileage, it is appropriate to take the first brake and then release the clutch.
The use of bulk feed vehicles during the adaptation period will have a great impact on the performance and life of the vehicle. Therefore, if you want to have a longer service life, you must pay attention to the above mentioned conditions during the run-in period.
Ceramic Jar,Ceramic Canister,Ceramic Canister Set,Kitchen Canister Sets
Guangdong Qunfa Ceramics Co., Ltd , https://www.qunfaceramics.com