1. Check the pressure drop of the school intercooler: Measure the pressure drop of the air - air cooler system with a mercury pressure gauge as follows: Install one end of the pressure gauge to the 1/8 inch of the booster compressor outlet elbow In the pipe thread, attach the other end of the pressure gauge to the 1/8 inch thread on the intake manifold . The school bus engine is operated at the specified maximum power of the school bus engine and the corresponding rotational speed, and the pressure gauge reading is counted. If the pressure difference is greater than 156 mmHg or 21 kPa , check that the intercooler and associated piping are blocked and, if necessary, clean and replace ;
2. Air leakage in the school intercooler Check: Install a pipe plug or cap on the outlet of the intercooler and install a pressure gauge, air supply pipe, and air pressure regulator on the cooler inlet. Apply 207 kPa to the cooler . The air pressure, turn off the air pressure regulator, observe the pressure gauge, and if the pressure drops within 49 kPa within 15 seconds , the cooler is normal. If it is exceeded, then determine if the pressure drop is caused by a leak in the intercooler or a leak in the fitting. Apply soapy water to the fitting and observe if bubbles are present .
3. If it is caused by a pipe joint, repair or replace the pipe joint and try again. If it is a leak in the intercooler, repeat the test three times to verify the accuracy of the pressure drop in order to confirm the repair or replacement of the intercooler.
School bus sales please call  Mobile Phone: 18727982266   0722-3256050     Sales Manager : Manager Zhang
The chips feature high dispersion, high transparency, high gloss, and bright color, without smell or dust, and meanwhile maintain stable performance, safety, and environmental protection, which generate great benefits in terms of storage and transportation. With its excellent compatibility and dispersibility, Keytec Pre-Dispersed Pigment Chips allow customers to prepare their ideal colorants in a short time. The relatively high pigment content generally ranges from 30% to 80% (which depends on system types), while the resin content can reach 20% to 70%.
CAB Predispersed Pigment Chips, Pre-dispersed Pigment Material, Pre-dispersed Pigment Paste
Guangzhou Quanxu Technology Co Ltd , https://www.skysilmattingagent.com