If the temperature of the water in the water tank of the bulk feed carrier is always at a high temperature, then such a situation will cause the combination of calcium, magnesium, and hydrocarbon ions in the water to form an inability to Water-soluble magnesium carbonate and calcium carbonate, this is what everyone said in the daily water base. Then, with the constant concentration of water and the law, the content of water alkali becomes scale after a constant addition until a saturated level. After the tank of the bulk feed carrier is used for a long time, the removal of scale will become difficult. However, if the cleaning is not done in time, the components inside the engine will be damaged. This will cause the fuel consumption of the bulk feed carrier to gradually increase. Therefore, cleaning the scale of the tank is also an extremely important issue. The common cleaning methods for water tanks can be divided into the following three types:
1. Manual cleaning: Disassemble the tank of the transporter and use a shovel, a scraper or an artificial hammer to clean the scale. However, such a cleaning effect is not very good, the efficiency of descaling is also relatively low, and its artificial labor intensity also consumes very well. If the scale is not clean, it will cause secondary damage to the vehicle's water tank.
2. The use of scale cleaning agent: the use of scale cleaning agent or the need to remove the tank of the bulk feed truck, but the effect of removal is not very thorough, the odor left by the cleaning agent will be relatively large, and its corrosiveness is also relatively strong , It will be easy for the tank to become old and shorten the service life.
3. Use professional vehicle water tank cleaners: The use of professional tank cleaners does not require the tank to be removed, and it can also be cleaned without stopping. Special detergents can be added to the water circulation system of the bulk feed carrier , allowing it to circulate slowly or after 20 to 30 minutes after the vehicle is normally running, and then discharge the vehicle tank and the descaling agent inside the system. If you drop it, you can rinse it with water repeatedly and repeatedly, so that you can effectively remove all kinds of harmful substances such as scale and water scale in the engine water circulation. (Text / Sun Ni)
Leading Laser Measure Module Factory in China
The World's First single transmitting single receiving design laser module, which has a big help to reduce producing cost and power consumption of the Laser Distance Sensor.
This Laser Distance Sensor has high Accuracy up to ±1 mm, working as phase measure, which support RS232/RS422/RS485/Arduino to TTL communication.
This Laser Distance Module is widely used in the Laser Distance Meter industry, also a very good choice for the Industrial applications. Most of measuring tools manufactures is purchasing from us in China.
Product Specifications:
|
Accuracy |
±1 mm (0.04 inch) |
|
Measuring Unit |
meter/inch/feet |
|
Measuring Range (without Reflection) |
0.03-150m |
|
Measuring Time |
0.1~3 seconds |
|
Laser Class |
Class II |
|
Laser Type |
635nm, <1mW |
|
Size |
45*25*12mm (±1 mm) |
|
Weight |
About 10g |
|
Voltage |
DC2.0~3.3V |
|
Electrical Level |
TTL/CMOS |
|
Frequency |
10Hz |
|
Operating Temperature |
0-40 ℃ (32-104 ℉ ) |
|
Storage Temperature |
-25~60 ℃ (-13~140 ℉) |
Laser Distance Sensor
Range Sensor,Laser Distance Module,Distance Sensor,Laser Measure Sensor
Chengdu JRT Meter Technology Co., Ltd , https://www.jrt-measure.com