The new connector supports high data transfer rates and low chroma luminance interference required by AMC. The optimized footprint is easy to route. A 0.55 mm PCB plated hole provides a full and reliable press-fit installation.
The new press-in design has optimized termination technology to provide a cost-effective solution. The press-in process allows the use of standard flat punches without the need for special tools.
This connector is also suitable for use in pinless applications not required by the ATCA Guide System.
At this time of Chair hardware should be flat or flip open, chair hardwares include shaft to open chairs or hinge and the chairs shut device such as pin.In order to improve the chairs the wind strength, it is widely used outside the chairs. But hinge must be exposed outside the chairs, the wind and rain erosion resistance of hinge became a problem. Now some of the more than one hundred old buildings in Europe, you can also see 10 times larger than present ordinary hinge of metal hinge, the hinge on the style and ancient European construction is harmonious.Outside the chair hardware of the another question is to prevent the casement of open type in free violently movement under the action of wind, so have the so-called limiter, the limiter in many ways are prone to failure parts.
Chair Hardware,Aluminum Die Casting Chair Hardware,Chair Hardware Parts,Chair Accessories Hardware
NINGBO ZHENHAI BOLANG METAL PRODUCT FACTORY , https://www.aldiecastings.com