Main Techical Parameters
Machine Layout
Coil Car&V Plate -- Decoiler -- Press&Guider -- Hydraulic Shovel -- Pinch&Pre-Leveler -- Hydraulic Shear -- Working Table -- Side Guide -- Slitter -- Scrap Rewinder -- Loop -- Damping&Pre-dividing -- Recoiler&Unload Car&Supporter
About Our Company
WUXI LONGAR MACHINERY MANUFACTORY Co., Ltd is a professional manufacturer and exporter for all kinds of Slitting lines and Cut to Length lines. In the past more than 15 years We have established and keep good business relationship with global customers on basic mutual benefits, contributing to our great business records and reputation. Our products are exported to American& European &South American& Africa &Asian market etc…
The thickness for Slitting line is 0.2-16mm, width range from 200-3000mm, with speed up to 180m/min.
The thickness for Cut to Length line is 0.09-28mm, width range from 200-3000mm, with speed up to 80m/min.
We have achieved CE certificate and SGS certificate .Â
Our goal is to supply highly quality personalized products by on time delivery with all around service at reasonable cost. Working to extend our presence internationally, we are looking forward to cooperating with your company for mutual benefit.
Wuxi Longar Machinery Manufactory Co.,Ltd
Wuxi Bono International Co.,Ltd
Factory: No.19 Jingxin Road, Xibei Industry Zone, Wuxi, Jiangsu, China
Office:Â No.1005, 39#, Liandong UÂ Builing, Beitang District, Wuxi, Jiangsu, China
http://www.wxlongar.com
http://www.wxbono.com
Tel:+86 510 82698581
Fax:+86 510 82610322
Mobile:+86 15298417602
Â
Â
Metal Body Square Water Cooling Tower
This series of products run stable, low noise, energy-saving, in office buildings, shopping malls, hotels, residential areas and other central air-conditioning supporting the use of better results.
The company's standard cooling tower according to the international design conditions design, can also provide customers with non-standard operating conditions or specific sizes under the special, special design.
The circulating water pump suction port shall be located below the water level of the cooling tower catchment basin, and the cooling tower outlet pipe shall not be allowed to be higher than the maximum water level of the catchment basin.
Pipe mounts should be pipe racks and cooling towers should not be allowed to directly bear the weight of the pipes.
The rehydration pipe of the cooling tower should be provided with a support stand to avoid vibration of the pipe when the float valve is rehydrated.
Rehydration pressure should be below 5m water pressure, national standard
The flannage pressure is 1.0Mpa.
When two or more units are assembled, our company will provide a connecting balance tube to balance the chassis water level. The tower top inlet should be set with a conditioning valve in order to enter each
.The water level of the tower is uniform.
The noise is measured at dm1.13VL-W at the equivalent diameter of the cooling tower (Dm1.13VL*W), 1.5 meters above the ground height, wherein L and W are the shape rulers of the tower
inch long and wide).
The use of cellular continuous blister series of diversion,heat dissipation, water collection three-in-one native filler, the whole suspension, gravity cloth water, low drop of water, with cold effect
High, low energy consumption, less drift water, less noise and so on, floating water rate is less than 0.001%.
When connecting different types of towers, the bottom basin water level height of different types of towers must be taken into account, and the base height must be adjusted to maintain the water level balance of the towers.
Metal Body Square Water Cooling Tower,Tower Water Cooler,Water Cooled Cooling Tower,Tower Cooling System
Wuxi Ark Fluid Science Technology Co., Ltd. , https://www.arkfluid.com